Classe Audio CA-5200 - MANUEL 2 User Manual download pdf (Page 90)

User's Manual

OPERATING BASICS

4-6

Disconnecting 3 1/2" diskette drive

When you have finished using the diskette drive, follow the procedures below to

disconnect it:

1. Wait for the indicator light to go out to make sure all diskette activity has

stopped.

CAUTION: If you disconnect the diskette drive or turn off the power

while the computer is accessing the drive you may lose data or damage

the diskette or the drive.

2. Click the Safety Remove Hardware icon on the Task Bar.

3. Click Diskette drive.

4. Pull the diskette drive connector out of the USB port.

Changing TOSHIBA Style Bay modules

This section explains how to change modules in the TOSHIBA Style Bay. The

illustrations show replacement of the DVD-ROM drive with the TOSHIBA Style Bay

HDD adaptor. Therefore, the text refers to those modules. However, the procedures

are the same for any of the modules: CD-RW/DVD-ROM drive, bridge media

adaptor, HDD adaptor, TOSHIBA Style Bay 2nd battery pack with separate tray or

weight saver.

CAUTIONS: 1. To avoid injury, do not put your hand into the

TOSHIBA Style Bay slot.

2. Before removing or installing a second battery pack,

turn off the computer’s power.

NOTE: The TOSHIBA Mobile Extension is preinstalled to support hot

swapping under Windows. Refer to Chapter 1, Introduction, and to the

utility’s online help files for information on using this utility to change

modules while the computer’s power is on. If you are using a Bridge

media adaptor, you can click the Windows Safety Remove Hardware

icon on the Task Bar to remove the Bridge media adaptor.

Removing a module

Remove the DVD-ROM drive as described below.

1. Check all disk indicators to make sure no disks are operating.

2. Turn the computer upside down.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 263 264

No comments

Classe Audio CA-5200 - MANUEL 2 User Manual Page 90