User's Manual
8-8
OPTIONAL DEVICES
7. Push the module down so it lies flat. Latches on either side will click into place
to secure the module.
Figure 8-6 Installing a module
8. Seat the cover and secure it with two screws.
9. Replace the battery pack as described in Chapter 6, Power and Power-Up
Modes.
10. Turn the power on and make sure the added memory is recognized. Open
System Properties in the Control Panel and click the General tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode then:
1. Be sure the power is off and all cables are disconnected from the computer.
2. Turn the computer upside down and remove the battery and two screws
securing the memory module cover.
3. Slide your fingernail or a thin object under the cover and lift it off.
4. Lift one side of the insulator and push the latches to the outside to release the
module. A spring will force one end of the module up.
Comments to this Manuals