Classe Audio CA-301 Owner's Manual download pdf (Page 6)

CA-301 ISSUE 1 MAY ‘99

STEREO (CONTINUED)

OVERTIGHTEN the output connectors. When powering up the P-303 in stereo mode, the front

LED will blink RED for approximately 20 seconds, when the sequence is completed, will be solid

RED.

MONO

Please read through the previous Stereo section for general notes on securing good

connections, and safety tips. If the unit has been previously used in stereo, make sure it is OFF, and

remove all connections, including the AC line cable. Make sure the STEREO/MONO switch is

switched to the MONO position. NOTE: The Stereo-Mono switch will not operate if the amplifier is

turned on, you will NOT be able to change from one mode to the other, as the mode is “locked”

while the amplifier is on.

The MONO "Input" is the "left channel input", as marked. The unused right channel

input is automatically disconnected. Correct output phase MONO connections are marked below the

connectors.

Repeat the above MONO settings and connections on the second P-303 to be used for the

other channel.

Please remember that the negative output connection of a bridged amplifier is NOT a

ground. Do not use a "common ground” switch-box set-up. Do not use with electronic crossovers

which have a common ground. Connecting two bridged amplifiers to a common ground device of

any sort will cause the amplifiers to fail.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Classe Audio CA-301 Owner's Manual Page 6