Classe Audio CRCD Operations Instructions download pdf (Page 5)

CE Declaration of Conformity

Classé Audio Inc. declares that this product is in conformance with the Low

Voltage Directive 73/23/EEC and Electromagnetic Compatibility 89/336/

EEC as amended by 92/31/EEC and 93/68/EEC.

The conformity of the designated product with the provisions of Directive

number 73/23/EEC (LVD) is proved by full compliance with the following

standards:

Standard number Date of issue Test type

EN60065 1993 General requirements

Marking

Ionizing

Heating under normal conditions

Shock hazards under normal

operating conditions

Insulation requirements

Fault conditions

Mechanical strength

Parts connected to the mains supply

Components

Terminal devices

External flexible cords

Electrical connections and

mechanical fixings

The conformity of the designated product with the provisions of Directive

number 89/336/EEC (EMC) is proved by full compliance with the following

standards:

Standard number Date of issue Test type

EN55013 1994 Conducted emissions

EN55013 1994 Absorbed emissions

EN60555-2 1987 Harmonics

EN60555-3 1987 Voltage fluctuations

EN55020 1994 Immunity

FCC notice

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of

the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

1 2 3 4 5 6 7 8 9 10 ... 45 46

Comments to this Manuals

No comments

Classe Audio CRCD Operations Instructions Page 5

Comments to this Manuals

Related products and manuals for Audio amplifiers Classe Audio CRCD