Classe Audio CAM-200 Owner's Manual download pdf (Page 8)

The CLASSÉ CAM200 power amplifier is equipped with both regular and balanced inputs,

either one may be used SEPARATELY, BUT NOT SIMULTANEOUSLY. Be sure that the CAM200 is

OFF before changing any connections.

When the amplifier is shipped from Classé, there is a jumper at the balanced input (XLR)

between pin 1 and 3. To use the amplifier in single ended mode simply connect a single ended inter-

connect from the preamplifier to the RCA input of the CAM200.

To use the CAM200 in balanced mode, remove the single ended interconnect and remove

the jumper at the XLR; please keep this jumper for later use; connect the preamplifier to the

CAM200 using balanced interconnect.

The XLR connector of the CAM200 is configured as below

PIN 1: DRAIN

PIN 2: POSITIVE (NON-INVERTED) SIGNAL, “HOT”

PIN 3: NEGATIVE (INVERTED) SIGNAL

All Classé preamplifiers and amplifiers have the same pin out configuration of the XLR. Other

manufacturers may have different XLR pin out configuration please contact the manufacture if you

wish to maintain absolute phase throughout your system when connect Classé’s equipment with

other manufacturer’s equipment.

Having confirmed or established the correct phasing, be sure the amplifier is off, then plug

the XLR connector of the balanced interconnect into the locking XLR connector on the rear panel of

the CAM200. Push the connectors in until the locking mechanism clicks. To remove the connectors,

press the tab above the connector while pulling gently on the connector body.

PROTECTION CIRCUIT

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Classe Audio CAM-200 Owner's Manual Page 8