Classe Audio CA-5200 - MANUEL 2 Specifications download pdf (Page 14)

14 C3696M-A (6/10)

To install the VCD5202 in a rack:

1. If chassis mounting brackets are not attached: Attach one mounting bracket (supplied) to each side of the VCD5202. Use four

10-32 x 0.25-inch Phillips pan head screws (supplied) for each bracket. Attach the brackets so that the tapered ends are positioned toward

the rear of the VCD5202 (refer to Figure 8 on page 13).

2. Remove the four rubber feet from the underside of the unit if they are attached. Save the rubber feet and screws for possible future use.

3. Attach one front-mount rail (supplied) to one rear-mount rail (supplied). Make sure the rails are mounted back to back, as shown in Figure 9.

Use three 8-32 x 0.375-inch Phillips truss head screws (supplied) in any of the available holes. Leave the screws loose until step 8.

Figure 9. Assembling a Support Rail

4. Repeat step 3 for the other rail set.

5. If installing the unit into a square-hole rack: Insert 10 cage nuts (supplied) into the square-hole rack as shown in Figure 10.

Figure 10. Inserting the Cage Nuts

(3) SCREWS, 8-32 X 0.375

PHILLIPS TRUSS HEAD

CAGE NUT

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Classe Audio CA-5200 - MANUEL 2 Specifications Page 14